Upholstered platform bed – A best trend in bedroom furniture is platform bed. The low profile and clean lines in the platform beds make them a perfect complement to a minimalist or modern bedroom design. Add some personality and style to your platform bed by padding the frame in a bold nuance or pattern. The construction frame itself allows you to polish when you build, allowing you to create a lush, tailor made look. In addition, constructing platform allows you to create a piece that fits perfectly into your room. Measure the length and width of your mattress. Cut two pieces of plywood measuring 14 inches long with the measurement corresponding to the length of the mattress. Cut two pieces of plywood measuring 14 inches long with the measurement equal to the length of the mattress. These will form your platform bed frame.
Upholstered platform bed, pull ½ inch from the width of the mattress. Cut five pieces of plywood measuring 14 inches of this measurement. Cut 21 pieces of plywood measuring 14 inches by 12 inches. These boards will form the supports in the platform bed. Add one foot to the length and width of the mattress. Cut your MDF plate into a rectangle that meets these adjusted measurements. Spray the front of one of your frame boards with spray glue. Roll the plate on a flat work surface. Place the board glue down on the plate. Wrap around the board as you would wrap a gift. Secure it in place by stapling around the perimeter of the board. Repeat with the remaining frame boards and MDF record.
Upholstered platform bed, roll your fabric faces down on the work surface. Place one of the batting covered boards down on the fabric. Wrap the board with fabric using the same method as the plate wrap. Repeat with the remaining frame board and MDF plates. Arrange frame boards to create a rectangle corresponding to the size of your mattress. Use your nail gun and penny nails to secure the boards.